- Fallback Mode – 0 to 4 seconds
- LED will immediately show blue light
- If the reset button is released while the light is blue, it will go into Fallback Mode
- This will likely bring the sensor online over the same IP with HTTP connection
- Sensor may take a new IP however
- The LED will remain blue for the first 5 seconds after the button is pushed
- Hard Reset – 5 to 9 seconds
- After 5 seconds the LED will switch to yellow for 5 seconds
- Release reset button to factory reset the sensor while LED is yellow
- A static IP configuration will be removed and sensor set to DHCP
- Sensor will reboot and will be on HTTP connection
- Sensor may keep the same IP if previously on DHCP, or take a new one
- No Change – 10 to 15 seconds
- 10 Seconds after the reset button is pushed the LED will turn off
- Release button and no change will occur
- If the reset button is still pressed after 15 seconds, the LED Light Cycle will then start again
