T20181108.0098 – Hermes00I90 – Prewired PC3D-R Installation (Surfaced Mount)** UPDATE UNIT FROM DHCP TO IP***

Hermes

Contract
Posted 3 years ago
  1. Contact support once you are on site (contact information listed in signature)
  2. Find package (Ask GC/GM where package is located)
  3. Test sensor comms (Hook sensor directly into switch, confirm if POE port, or POE Injector)
  4. Send photos (Network room, network switch, 2x Wide angle at each entrance from inside the store)
  5. Send measurements (Mounting Height, Entrance Width)
  6. Terminate cable run with T568B
  7. Mount sensor in mockup position (mockup provided by tech support)
  8. Send photo’s (Wide angle shot of entrance, close up of sensor, labeled network cables, where POE Injector is left)
  9. Send network switch info (Switch make and model, port number for each sensor, patch panel port number for each sensor)
  10. Count test (Stand under sensor to verify sensor height, Entrance under 6′: 5in/5out, Entrance over 6′ 10in/10out)

Job Features

Job CategoryInstallation
PC3D Surface Mountpc3d-surface-mount
PC3D Recessed Kitpc3d-recessed-kit

Apply Online

A valid email address is required.
A valid phone number is required.