How Can We Help?
Brickstream Recessed Installation
Instructions
- Contact support once you are on site (1-855-885-4888)
- Find package (Ask GC/GM where package is located)
- Test sensor comms (Hook sensor directly into switch, confirm if POE port, or POE Injector)
- Send photos (Network room, network switch, 2x Wide angle at each entrance from inside the store)
- Send measurements (Mounting Height, Entrance Width)
- Check above ceiling at mockup location for clearance for recessed kit (1 foot wide, and 1 foot high above ceiling)
- Once approved to proceed with install by Support, make 6.75 inch x 2.75 inch square hole for recessed kit, and mount sensor in mockup position.
- Terminate cable run with T568B
- Mount sensor in mockup position (mockup provided by tech support)
- Send photos (Wide angle shot of entrance, close up of sensor, labeled network cables, where POE Injector is left)
- Send network switch info (Switch make and model, port number for each sensor, patch panel port number for each sensor)
- Count test (Stand under sensor to verify sensor height, perform walk tests as directed by Prodco Support 15 in/15 out)
- Once all work has been completed the tech support agent you’re working with will send a close out form link to be completed with the manager/GC on site.