Skip to content

How Can We Help?

Fitting Room Installation

You are here:
< All Topics

Instructions

  1. Contact support once you are on site (1-855-885-4888)
  2. Find package (Ask GC/GM where package is located)
  3. Test sensor comms (Hook sensor directly into switch, confirm if POE port, or POE Injector)
  4. Send photos (Network room, network switch, 2x Wide angle at each entrance from inside the store)
  5. Send measurements (Mounting Height, Entrance Width, Distance to mockup location from entrance) (mockup provided by tech support)
  6. Check above ceiling at mockup location for clearance for recessed kit (1 foot wide, and 1 foot high above ceiling)
  7. Terminate cable run with T568B (If not already terminated)
  8. Send photos (Wide angle shot of entrance, close up of sensor, labeled network cables, where POE Injector is left)
  9. Send network switch info (Switch make and model, port number for each sensor, patch panel port number for each sensor)
  10. Count test (Stand under sensor to verify sensor height, perform walk tests as directed by Prodco Support 15 in/15 out)

Full Guide

Ralph-Lauren-Fitting-room-installation-instructions